The three-head grinder is a device that grinds samples finely by dry method. It is mainly composed of three sets of grinding heads, a box remover, a mortar support, and a positioner. It is used for grinding and analyzing samples in various industries. Wide range of uses, welcomed by users. There are many things to pay attention to when using this grinding equipment, namely, the four aspects of loading, grinding, unloading and indexing, which will be described in detail below.
The first step in the use of the mortar and pestle grinder is to load the material. First, lift the grinding head of triple grinding miller, put the abrasive into the bowl, then cover the cover on the grinding body, and put down the grinding head. Then start the motor, and after the handle of the clutch rotates clockwise, close the friction clutch, and the grinding head will start to grind materials at this time.
The next step is to unload the material. Turn the clutch handle in the opposite direction to stop the grinder.
When lab three grinder miller stops moving, put the container with the material on the receiving rack. Then turn the handle to let the grinding body rise to the material receiver. At this time, the material in the bowl body can be put into the material receiver. After putting the grinding body back, you can start charging again for the next grinding.
